Army Researchers Demonstrate 3-D Printed Drones

The 3-D printed On-Demand Small Unmanned Aircraft System, or ODSUAS, flies at speeds of up to 55 miles per hour. Although the lightweight shell and propeller arms are printed using additive manufacturing, the motors and propellers will be assembled using off-the-shelf equipment. (Photo: Angie DePuydt)

Soldiers witnessed the innovation of Army researchers recently during flight testing of 3-D printed unmanned aircraft systems that were created on-demand for specific missions.

"We've created a process for converting soldier mission needs into a 3-D printed On-Demand Small Unmanned Aircraft System, or ODSUAS, as we've been calling it," said Eric Spero, team leader and project manager. With this concept, once a patrol requires UAV support, soldiers input all their requirements into mission planning software. The system then knows the optimal configuration for the aerial vehicle and it's printed and delivered within 24-hours.

The team spent many hours flight testing and verifying the designs to make sure everything was going to work the way they expected. "It was good that we didn't have any mistakes on game day," said fellow engineer Nathan Beals. "The day before we did some test flights and worked out some kinks. I think we had the quad up to 55 miles per hour."

Spero said based on feedback from Army leaders, his team hopes to work on low noise, long standoff distance, heavier payload capacity and better agility. “I'm very optimistic that most of those are achievable. I think the hardest one that's going to be achievable is the heavy payload.”

Soldiers at AEWE also became fascinated with 3-D printing technologies, Spero said. "Before we even started the briefing, we set up the 3-D printer in the conference room and started a print job," Spero said. The researchers printed a Picatinny Rail, which is a bracket used to mount accessories on a small arms weapon, such as an M4 carbine. In about two and a half hours, they had a rail that fit the soldiers' weapons perfectly.

They asked the group what other kinds of 3-D printed items they could use. In a matter of hours, the team presented a variety of functional printed parts that impressed the soldiers. The Army engineers continue to collaborate with partners at the Georgia Tech's Aerospace Systems Design Lab as they continue to refine technologies for future Soldiers.

Source